HERO 100+

HERO 100+ 

WATERJET INTENSIFIER PUMP

High Velocity Stream of Ultra High Pressure Water

The HERO 100+ Waterjet Intensifier Pump, provides the power to drive greater water volumes at Ultra High Pressure utilizing Jet Smart+ Controls.  By adding the plus, a host of additional premium features including a Soft Start Motor Starter, Light Stack with audible warning, electronic hydraulic pressure control, check tube sensors, bleed down sensor and auto leakage sensor. Teamed with a Jet Edge motion system, multiple cutting heads can be configured for both waterjet cutting and abrasive waterjet cutting.

Jet Edge allows you to Custom Configure your Intensifier Pump to match your unique application with the best value. If you require an engineering analysis to proof your processing goals, request a Free Application Analysis.

Jet Smart+ Controls make the user interface simple.  Quickly set pump pressures, visualize intensifier cycles, receive performance feedback in real time and receive prompts for scheduled maintenance.

  • Rated pressure: 60,000 psi (4,100 bar)
  • UHP flow rate: 2.1 gpm (7.9 lpm)
  • Max rated orifice size 0.020 in (0.51 mm)
  • Two single piston, dual plunger intensifier with
    tie rod design
  • Motor output: 100 hp (75 kw)

Category:

Description

CONSTRUCTION

  • Heavy-gauge sheet metal covers
  • Rugged all-steel welded framework
  • Hinged cover & quick-remove access covers
  • Sound Insulating Kit

JET SMART+ CONTROLS

  • Advanced Controls Touch Screen
  • Maintenance schedules with prompts
  • Soft Start motor starter
  • Remote pump start
  • Dual pressure set points
  • Check tube temp sensor
  • Bleed Down temp sensor
  • Auto leakage sensor
  • Electronic hydraulic pressure control
  • Optional remote analog pressure control
  • Light stack beacon with audible warning

INTENSIFIER PUMP

  • Rated pressure: 60,000 psi (4,100 bar)
  • UHP flow rate: 2.1 gpm (7.9 lpm)
  • Max rated orifice size 0.020 in (0.51 mm)
  • Two single piston, dual plunger intensifiers with tie rod design
  • Single, 2 quart (1.9 liters) attenuator
  • Incoming water control
  • Optional boost pump

ELECTRIC MOTOR

  • Motor output: 100 hp (75 kw)
  • TEFC NEMA premium efficiency motor
  • Full load amps @ 460vac: (60Hz) 121

WATER/ENVIRONMENT

  • Low-pressure process water supply requirement: 2.1 gpm (7.9 lpm) @ 30 psi (2 bar) min
  • Max water temp: 70ºF (21ºC)
  • Ambient air temperature: 50–100ºF (10–37ºC)

HYDRAULICS

  • Axial piston, variable displacement, pressure-compensated hydraulic pump
  • Thermostatically-controlled cooling loop (requires additional water supply)
  • Hydraulic accumulator prolongs component life and improves output quality
  • Reservoir capacity: 103 gallons (390 liters)

WARRANTY

  • 1-year or 2,000-hour pump warranty
  • 2-year or 4,000-hour hydraulic circuit warranty
  • Extended Warranty Available
  • Technical service and free lifetime factory training