Spyder Abrasivejet Radius & Circle Cutting System

SPYDER ABRASIVEJET

RADIUS & CIRCLE CUTTING SYSTEM

For Use in Remote and Hazardous Environments

Jet Edge’s Spyder Abrasivejet Radius and Circle Cutting System can be set up on the side of tanks, small vessels and large diameter piping. It is held in place by vacuum cups and features a self-aligning centering pin for fast and reliable setup. Motion components are made from non-ferrous materials, and cutting head manipulators are powered by pneumatic motors, making the Spyder suitable for use in all environments. A master control panel allows operators to control the cutting head manipulators, direction, speed of travel, abrasive delivery and vacuum components from one location.

  • Pneumatic reversible drive motor
  • Self-aligning cutting
  • Multiple diameter sizes
  • Lightweight suction cup mount

Description

EAST SET UP

  • Self-aligning
  • Lightweight suction cup mount

MOVEMENT SPEED

  • Varies due to several ranges of gear reducers
  • Optional Linear and Pipe Cutting Tracks
  • 3, 5 and 10 linear-foot tracks
  • Low profile, rigid and vacuum tracks available
  • Pipe track: 6–60 inches (152–1524 mm)

VACUUM GENERATOR

  • Steel construction
  • Pneumatic control vacuum
  • Locking quick disconnects
  • Lightweight compact design

PERMALIGN II ABRASIVE HEAD

  • Length 10.94 in (27.8 cm)
  • Weight 4.00 lbs ( 1.8 kg)
  • Water pressure (max) 60,000 psi (4100 bar)
  • Operating air pressure (min) 60 psi (4 bar)
  • Orifice range .003 – .023 in
  • Nozzle range .020 – .065 in ID
  • Max flow rate 2.1 gpm (7.95 lpm)

ABRASIVE DELIVERY SYSTEM

  • Lightweight durable high-impact poly design
  • Two-wheel pneumatic tires with rugged frame
  • Air-regulated metering valve
  • Delivery rate: up to 3 lb (1.36 kg)/minute

AVAILABLE IN TWO SIZES

  • 1”-6.5” insider diameter/16“-48” outside diameter
  • 3“-12.5” inside diameter/27.5“-56” outside diameter

MASTER CONTROL STATION

  • Three-position directional valve for pneumatic drive unit
  • Dual air regulators for directional speed control
  • Control abrasive flow from control station
  • One palm button shuts off UHP water and abrasives

HEAD MANIPULATOR

  • Drive unit adapts for use with track or pipe cutting bands
  • Pneumatic reversible drive motor with interchangeable gear drive
  • Precise speed control for accurate cutting feed rates
  • Center line mounting of abrasive cutting head
  • Adjustable angle for beveling cuts

HIGH FLOW ABRASIVE HEAD

  • For cutting thicker material or multiple layers
  • Length 7.55 in (19.1 cm)
  • Weight 4.00 lbs ( 1.8 kg)
  • Water pressure (max) 55,000 psi (3800 bar)
  • Orifice range 0.023-0.042 in
  • Nozzle range 0.095-0.125 in ID
  • Max flow rate 5.1 gpm (19.04 lpm)