CASE STUDY: PLASTI-FAB
Plasti-Fab found what they were looking for with Jet Edge. Now they are faster, taking on bigger projects, and floored with the results of their iP60-50 intensifier pump.
Lorem ipsum dolor sit amet, consectetur adipiscing elit. Etiam tincidunt justo non justo hendrerit volutpat. Donec fermentum leo sed lacus laoreet, nec semper turpis commodo.
CASE STUDY: METFAB
From a simple three-car garage to a 50,000 square foot manufacturing facility, Metfab found the edge they needed with their Jet Edge Intensifier Pump and High Rail Gentry.
CASE STUDY: GULF MACHINE SHOP
Gulf Machine Shop installed a Jet Edge X-5 5-axis system, giving them the ability to take on a wider range of opportunities, materials, and more elaborate cuts.
CASE STUDY: AQUABLAST
Aquablast is known for their dependability and minimal downtime. With the help of Jet Edge, they can add ‘built to last’ to their reputation.
CASE STUDY: ALLIANCE AUTOMATION
Alliance Automation knew that if their pump went down, their profits would go down with it. They decided to go with Jet Edge iP60-50 intensifier pumps for reliability and grit.
EDGE X-5, 5-AXIS MID RAIL WATERJET
The Edge X-5 features 5-axis waterjet cutting that is capable of bevel cutting to 60°. Complex 3-D parts, including impellers, gears, and other precision parts can be cut in the hardest materials with a taper-free finish. Controlled with the fully networkable Aquavision DI, the system offers a host of options to custom configure it to your operation’s needs. Coupled with a Jet Edge HERO Pump, your system is ready for high volume 5-Axis Abrasive Waterjet cutting!
EDGE DUAL CARRIAGE, 3-AXIS MID RAIL WATERJET
This Edge X3 Dual Carriage Waterjet System employs two 3-axis cutting heads. These systems can also be equipped with multiple 5-axis cutting heads and/or a combination of both 3-axis and 5-axis heads giving you the flexibility you need for your application.
EDGE DUAL CARRIAGE, 5-AXIS MID RAIL WATERJET
The Dual Carriage Waterjet System employs two cutting heads. These systems can be equipped with multiple 5-axis cutting heads and/or a combination of both 3-axis and 5-axis heads giving you the flexibility you need for your application.
JET START 510A & 510A5 3 AND 5-AXIS MID RAIL WATERJET SYSTEMS
This 3-axis, single carriage waterjet cutting machine excels at high-speed waterjet cutting and abrasivejet cutting. Pair it with a HERO 50 Ultra High-Pressure pump for optimum performance. Trade up to a 5-axis abrasive water jet and breeze through 6” stainless steel plate and 20” aluminum block cutting near-net shapes with beveled edges up to 60° with no taper.
EDGE X3-HR, 3-AXIS HIGH RAIL WATERJET
The Edge X3-HR, 3-axis motion system is customizable for high speed processing. By attaching a precision machined Spreader Bar to the Z Carriage, up to ten sub-Z cutting heads can be mounted allowing you to cut ten identical parts in one cycle. The independently controlled Sub Z’s can handle water only cutting, abrasive cutting or both. Heads can be positioned manually or positioned via your program. Incorporate load/unload systems for the highest efficiency levels achievable with water jet cutting.